• Out-of-Stock

Quinta Studio - Yak-1 (middle production) 3D-Printed & colored dashboard on decal paper (for SF and Modelsvit kit) - 48003D

$6.00

Quinta Studio - Yak-1 (middle production) 3D-Printed & colored dashboard on decal paper (for SF and Modelsvit kit) - 48003D

Quantity
Out-of-Stock

Quinta studio's QD48003-Base Yak-1 (middle production) 3D-Printed & coloured Interior on decal paper, base skill (for South Front and Modelsvit kit) - a set of interior elements for installation on the same parts in the SouthFront or Modelsvit kits

This set combines traditional water-slide decal technology with colour 3D-printing.

The 3D decal has prominent multi-level details, such as recessed flight instrument dials, prominent dashboard, and equally prominent small details, such as toggle switches, buttons and signal lights.

Each instrument dial is covered with a layer of gloss varnish, giving it a characteristic glass-like shine at sharp viewing angle.

Decals are designed for this particular kit and fit perfectly.

Use warm water to separate the decal from its base, as you would with traditional water-slide decal.

Since 3D-decals are significantly thicker than traditional ones, use additional adhesive (water-based adhesive is recommended) or acrylic varnish (Tamiya X-22 or Future) to fix the decal in place.

Usage of decal setters (Micro Set / Sol, Gunze Mr. Decal setter, etc.) is NOT advisable – decals conform well to the plastic surface, and irrepairable damage to the decal can occur.

A small photo-review is included for the product.

QS-48003-Dash

Specific References