ZP - Etch Primer for Metal/Resin 120ml - 3007
Two pack anti-corrosive Grey Etching Primer for Metal and Resin (Suitable for White Metal, Resin and Photoetched Parts)
Contents: 60ml Etch Primer and 60ml Hardener supplied in Glass Jars.
Spray Application.
Mixing ratio by volume
Primer (Grey Liquid) 60 ml to Hardener 60 ml (ONLY MIX WHAT YOU REQUIRE EACHH TIME)
Prepare the mixture in a plastic beaker DO NOT USE metallic containers.
Once mixed Pot-life is 24 hours @ 20° C
Drying Time
Air drying at 20 °C: - Dust free: 8-10 min. - Handling: 20 min. - Through drying: 60 min.
If required sand using 3600 grade or higher Micromesh or Ultra Fine Scotch Brite Pads
Once applied thoroughly clean your Airbrush A.S.A.P. as the Primer will damage your Airbrush if left.
Characteristics
Excellent adhesion on Iron, Steel, Aluminum and White Metal, Light Alloys, Zinc-coated Metal and Stainless Steel, Good covering power, Fast drying, Chromate-free and lead free
Health and Safety Notes :
Highly flammable. Irritating to eyes and skin. May cause sensitization by skin contact.
Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment.
Vapors may cause drowsiness and dizziness. Keep container in a well-ventilated place.
Avoid contact with skin. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
Wear suitable gloves. If accidentally swallowed obtain immediate medical attention. DO NOT induce vomiting.