Master - Fokker E.II/E.III...
Master - Fokker E.II/E.III (Early) - ammunition feed chute with belt for LMG 08 Spandau (for Wingnut Wings kit) - 32-105
A4 sheet of 4 color lozenge decal. For more realistic look colors were faded. Decal is tranparent, so it is necessary to apply it on the prepainted surface. This accessory is available in 1/32 scale.
Pasted/fixed/glued, puttied and polished model paint by base white (it is suitable to polish also this colored layer before applying wooden decals). The decals are transparent, so it is necessary to apply base colour. It is possibe to mark off single panels by using different shades of base colour (white, of white, yellow). Then cut required shape of panel (with 2 mm overlap) and apply as same as ordinary decal. After these processes cut protruded wooden decal with very sharp knife.
By this technique it is possible to create very believable imitation of the wooden surface without skill in using of oil paints. Finally it takes cca 4 hours to cover whole fuselage of Albatros D.Va (1/32 WNW).
Master - Fokker E.II/E.III (Early) - ammunition feed chute with belt for LMG 08 Spandau (for Wingnut Wings kit) - 32-105
Worn rubber pads T48 type for M4 Sherman, only pads 180 pcs, an additional set of end connectors is required
DEF - US M54A2 Cargo Truck Sagged Rear Wheel set- Standard loaded (for AFV club 1/35) - DW35116
Quinta Studio - F-16D (block 30/40/50) 3D-Printed & colored Interior on decal paper, extended el-ts (for Kinetic kit) - 48045 Pro