HGW models Laser SEATBELTS in 1:32 scale

• microplastic sheeting, metallic buckles
• it is possible to make seat belts fully functional - un/buckle, un/fasten them
• made by special microplastic foil which is printed and behaves like a rag
• set contains seat belts for 2 single-seater aeroplanes
• microplastic parts are prepared to using filters - it leads to darkening shades - and these are also waterproofedand resistant to normal nonaggresive modeller preparations
• photo-etched parts were developed in cooperation with Eduard company

INSTRUCTIONS

1. Take the precut textile part out of the sheet

2. Remove supporting paper

3. Crumple the belt into a little ball and knead it between the fingers

4. Thread the belts through the buckles – use superglue

5. Put the belts into the seat

6. Spray by the glossy varnish

8. Spray by matt varnish

7. Impregnate the belts with very diluted oil color (mix of black and brown) – it will highlight the texture