HGW models SEATBELTS in 1:32 scale

- this set is designed for Wingnut Wings and Roden kits

• textile sheeting, metallic buckles
• it is possible to make seat belts fully functional - un/buckle, un/fasten them
• made by special micro-textile foil
• set contains seat belts for 2 single-seater airplanes
• textile parts are prepared to using filters - it leads to darkening shades - and these are also waterproofed and resistant to normal nonaggressive modeler preparations
• photo-etched parts were developed in cooperation with Eduard company

INSTRUCTIONS

This set contains printed and photoetched parts. Choose appropriate shade of belt and trim on dotted line using very sharp knife. Trim to required length according to the type of seatbelt. Using fingers munch into little ball. Flatten out and thread through photoetched parts. Glue using white glue, do not use chemical glue that etches plastic. When applying, look at photos of cockpit of individual machines. After glued and shaped, paint with matt varnish.